Testing Furnace Pressure Switch

Hook a manometer to the tubing and check the draft from the heat exchanger in inches w c.

Testing furnace pressure switch.

Check for obstructions in the hose. Ensure the draft is above the required pressure. The steps are as follows. If there is no disconnect.

Turn off the power to the furnace by switching off the disconnect switch located near the furnace. The pressure switch has a pressure at which it closes which is typically negative. With a manometer or magnahelic. To test the pressure switch use a multi meter and measure the continuity of the switch as it opens and closes.

Probe one lead of the pressure with one lead of your meter while touching the other lead of your meter to. The draft inducer should start. The switch is being tested to check if it s closing when the diaphragm is pulled in. A multimeter is used to test the pressure switch and check the continuity of the switch whether it is closed or it is opened.

How do you test the gas furnace pressure switch. There should be either two or three wires going into your pressure switch. Basically the switch needs to be tested to see if it is closing when the pressure diaphragm pulls in. Set your meter to volts ac turn your furnace on so it is calling for heat.

Turn off the power. Inspect the pressure switch hose. To do this the pressure switch wires are removed and the furnace turned on.